RECOMMENDED USE

In front of a standard size of 50 mm x 60 mm, this tooling can be provided of all proportions.

CHARACTERISTICS

This equipment is taken out from empty, high thickness tube in steel, to make an easier heat transfer when the rolled tube is put in a hovel. The ends, made in a lathe so that the entire equipment can be put in a standard roller, have an initial square section to make a correct housing in its support, so that you can cut the tube perfectly in the middle.

WHERE TO USE IT

You can use this tooling in every kind of coiler, then you can cut the coil in every sawer, with its support.

MAINTENANCE

No maintenance needed.

TECHNICAL DATAS

Dimensions of equipment: 500 mm x 120 mm x 70 mm
Material: C40
Dimensions: of tubes All dimensions
Total weight: 5 Kg
Design: On demand